CBR is for connections that support constant rates of data transfer. The Dynamic Route field controls the format and the broadcasting method of RIP packets that the router sends. Double-click Network Connections icon. Page 9 With Dynamic DNS support, you can have a static hostname alias for a dynamic IP address, allowing the host to be more easily accessible from various locations on the Internet. Accessing your router’s configuration interface To connect to your router’s web interface, follow these steps:

Uploader: Akinolkree
Date Added: 10 October 2007
File Size: 56.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97564
Price: Free* [*Free Regsitration Required]

Click on Access Management to manage Internet access options. Double-click Network and Sharing Center icon.

ENDSL-A2+WIGX2. ADSL2+ Modem With Four Port Ethernet and g Wireless Router. User s Manual – PDF

VPI can range from 0 to Encore Electronics Hardware Type: The Beacon Interval value indicates the frequency interval of the beacon. The only difference is the interface. Enter the VPI here. Page 24 Step 3: Lease Time Enter the amount of time you wish to lease out a given IP address.



You must register for ensl service with a Dynamic DNS client. Trademarks Preface D-Link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes.


To install your HomePortal and configure your home network, follow these steps.

Sustained Cell Rate SCR is the mean cell rate of a bursty, on-off traffic source that can be sent at the aigx2 rate, and a parameter for burst-type traffic.

Each of the device s interfaces can be configured as a DHCP relay. Select which mode your ADSL connection uses from the dropdown list. You can specify up to 10 rules.

The Beacon Interval value indicates the frequency interval of the beacon. Select your encapsulation type from the dropdown list. Click on Maintenance to set a new password, to set the time zone, to upgrade or aa2 firmware and to run diagnostic tests on the router Click on Status to see router device information, system logs and performance statistics.

Nat Announced in RIP: Setup The Setup screen is the first screen you will see when accessing the Gateway. Some Encore routers come with default network names with the name of the manufacturer.

SG :: Encore ENDSL-A2+WIGX2 DSL Wireless Router

This parameter may be lower but not higher than the enddl line speed. This Wizard is a helpful guide for first time uses to the device. Type the new password in this field.


This Wizard is a helpful guide for first time uses to the device. Enter the static IP address here.

Encore ENDSL-A2+WIGX2 User Manual

And once there is traffic send or receive, the connection will be automatically on. Wigx22 is a session-layer protocol used to establish membership in a multicast group.

Enter a value between 0 and Fragment Threshold: Support hotline information can be found on our web site at www. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Select the Interface you want to access from. Select Deny Association to block access to the router, MAC addresses not listed will be allowed to access the router. The following illustration shows the relationship between the router and the two different networks.

Wireless Broadband Router Manual 1 Introduction In computer networks, a DMZ demilitarized zone is a physical or logical sub-network that separates an internal local area network LAN from other untrusted networks, usually the Internet.

Author: admin